Montrose

Large Wood Fireplace

Crafted with contemporary living in mind, the Regency Montrose brings warmth and charm to any space it graces. Its expansive viewing glass, accented with a sleek black etched edge, offers a captivating glimpse of the dancing flames, enhancing the aesthetic of any home decor.

The Montrose is ingeniously designed to seamlessly integrate into custom-built walls, eliminating the need for a traditional brick fireplace or chimney. This versatile slow combustion heater puts you in control, allowing you to optimise heat output while conserving wood usage.

Engineered to not just meet but surpass the most stringent Australian standards for emissions and efficiency, this heater represents the pinnacle of heating technology, ensuring both environmental sustainability and superior performance.

 

Standard Features

• Heats approx. 100+ sq.m* (no fan)
• Heats approx. 200 sq.m* (fans fitted) using ducting kits
• Large glass viewing area (790mm x 310mm)
• Single draft control with airwash
• Removable door handle tool
• 5mm steel firebox – lined with high quality firebrick
• Stainless steel andiron
• Clean front trim
• Zero clearance box included
• Low emissions: 1.2g/kg
• 62% efficiency

Options

• Black 4 sided fascia
• Slim line finishing trims available (15mm & 50mm)
• Base frame kit – raises unit 300mm on sturdy steel frame
• Heat distribution kit with flexible ducting, up to 2 can be used
• Outside air kit with flexible ducting
• Triple skin, zero clearance, wood fire flue kit available

* Heating capacity and any burn times are a guide only and can be affected by some or all of the following examples: drafts under doorways or between floorboards, large glass areas not covered by heavy drapes/curtains, green, wet or damp wood, ceiling heights greater than 2.4 metres or cathedral type ceilings, poor or no insulation.

Specifications (mm)

*NOTE: Finishing material underneath clean front
trim to floor includes base support of 300mm,
therefore minimum 497 mm is required.

Framing

Clearances

Heat Distribution

Increase the effectiveness of your fireplace by dispersing warm air from the fireplace to remote locations in the same room or other rooms in your home by using the heat distribution kit.

Note: Heating capacity and any burn times are a guide only and can be affected by some or all of the following examples: drafts under doorways or between floorboards, large glass areas not covered by heavy drapes/curtains, green, wet or damp wood, ceiling heights greater than 2.4 metres or cathedral type ceilings, poor or no insulation.

All product specifications are subject to change without notice. Before installing refer to the relevant product manual for full and up to date information. Product pictures are a guide only, all wood fires must be installed as per AS 2918 :2001. All Regency wood fires exceed stringent joint Australian and New Zealand Standards ASNZS 4012/4013 (2014). Not all products are available at all outlets.